News

News Center

Current location: home page > News Center > FAQ

Common fault causes and treatment of emergency fire lighting lamps

2022-10-10 14:02:35
second

If you want to use the emergency lighting for a long time, you should maintain it on time in the daily use process, and learn how to eliminate the failure of the lighting. Let's introduce it to you today Shenyang emergency fire lighting Common fault causes and solutions are provided.

1. The main power supply is normal, but the indicator is not on.

The fault is mainly caused by the damage of LED. It can be welded. You can use a multimeter to judge whether it is in good condition. The greater the current limiting resistance R1 or the open circuit resistance, the less bright it will be.

2. When the power supply is cut off, the indicator light is still on.

The fault is caused by deterioration or breakdown of the reverse characteristic. The fault can be eliminated by replacing an IN4004 rectifier diode.

3. After the power is cut off, the brightness of the lamp will decline after a period of normal operation.

This indicates that the battery may be faulty. Because there are no protective measures for the circuit to prevent battery load, if the power supply is cut off for a long time, the battery cannot be disconnected. When the terminal voltage of the battery discharges 10v, the battery will discharge and its pole plate will be damaged prematurely. A better solution to battery over discharge is to establish a protection circuit. The circuit is relatively simple. In the process of emergency lighting, when the terminal voltage of the battery is lower than 10V, VD will be cut off, relay KA will be released, and the load circuit of the battery will be cut off to avoid over discharge and shorten the service life of the battery. KA can select domestic JRX-13F high sensitivity relay, with pull in current of 8mA and pull in voltage of 6V. The voltage stabilizing value of the voltage stabilizing diode is 5V.

4. Emergency lighting lamp circuit failure

Switch function SA2 emergency lamp circuit: when SA1 is off, SA2 is placed at the "start" position, L1T2 of voltage oscillation transformer on winding is applied to one end of filament tube of lamp through SA2 and ground power supply (battery), and L3 of voltage on winding is applied to the other end of filament tube. After preheating for about 3 seconds, turn switch SA2 to the "ON" position. At this time, the high-frequency pulse voltage induced on L2 winding acts on both ends of the lamp, and the lamp turns on.

According to the working principle introduced previously, when troubleshooting failed lighting tubes, first check whether the switch is in good contact, then check whether the filament tube of the lamp is in good condition, and use a multimeter RX1 to measure its resistance. Since the filament of the emergency lamp is preheated and the capacitor C3 improves the voltage waveform, it is not common for one end of the lamp to blacken.

The content of this article comes from the network. If you have any questions, please contact me to delete it!


 Shenyang emergency fire lighting

Recent browsing:

Service telephone:

024-25815838

Contact: Manager Ding

Tel: 15940588108

Tel: 13840299370

Service hotline: 024-25815838

Fax: 024-25815007

Address: No. 1105, Zhangshi Lantern City, Tiexi Economic Development Zone, Shenyang

Case presentation +